The original control panel wood was replaced. Too much wood to properly place the CPO back on top of it (there are screw attachments on the bottom). So, I broke out the jigsaw, and just started cutting away.
Right now I can get it so it lays flat, but then I turned it over to see where the joysticks would hit. I still have some chunks to remove.
There are twelve carriage bolts holding on the monitor enclosure and the cabinet body. I’ve been removing them three at a time, […]
Examined the main boardset today. I had remembered seeing a couple gouged traces on initial examination. So today I dragged it out […]
Really should have gotten some pictures of this before I started work on it. Two years ago, when I took a tour […]
Had a little slack time at work today. Decided to tackle the gouges taken out of the board and patch them up. […]
